Grizzly Power Roller T10114 User Manual

MODEL T10114  
HEAVY-DUTY  
ROLLER STAND  
INSTRUCTIONS  
Introduction  
Assembly  
Refer to Figure 1 and the Parts Breakdown illus-  
tration to aid you during assembly.  
The Model T10114 Heavy-Duty Roller Stand is  
vertically adjustable from 2614" to 41" with the  
use of a crank handle and the attached elevation  
gears, as shown in Figure 1.  
Tools Needed  
Qty  
Phillips Screwdriver ........................................... 1  
Hex Wrench 3mm.............................................. 1  
Wrench or Socket 10, 13mm....................1 Each  
To assemble your roller stand:  
Roller  
Lock  
Knob  
1. Thread the four foot pads into the base.  
2. Secure the bottom vertical support onto the  
3
base by threading the 8"-16 x 1" hex bolt,  
lock washers, and flat washers through the  
bottom of the base and into the support.  
Crank  
Handle  
Elevation  
Gearbox  
3. Insert the top vertical support into the bottom  
support with the horizontal slits facing toward  
the gear assembly mounting.  
4. Position the elevation gearbox onto its mount-  
ing point and make sure the gear teeth mesh  
with the slits in the top vertical support, then  
Adjustable Foot Pad  
Figure 1. Model T10114 identification.  
1
1
secure the gearbox with the four 4"-20 x 2  
Phillips head screws.  
"
Inventory  
After removing the contents of the shipping  
package, lay them out and refer to the Parts  
Breakdown on the back page to inventory the  
components.  
5. Align the set screw in the crank handle hub  
with the flat of the gear assembly shaft, slide  
the crank onto the shaft, then tighten the set  
screw to secure it in place.  
If you need help with your new roller stand, call  
our Tech Support at: (570) 546-9663.  
6. Thread the two lock knobs into the holes on  
the side of the bottom support.  
7. Attach the roller bracket to the top verti-  
1
1
cal support with the four 4"-20 x 2" flange  
bolts.  
8. Insert one side of the roller axle into a mount-  
ing hole on the roller bracket, then push in on  
the other end of the spring-loaded axle until  
you can insert it into the remaining mounting  
hole.  
 

Grizzly Meat Grinder H6247 User Manual
Grizzly Saw G0697X User Manual
Haier Washer XQB60 C User Manual
Hamilton Beach Mixer 63220 User Manual
Honeywell Home Security System 800 06894 User Manual
Hotpoint Clothes Dryer TDL12 User Manual
HP Hewlett Packard Photo Printer Z6600 User Manual
HP Hewlett Packard Tent HP 53310A User Manual
Humminbird Fish Finder 1197C SI User Manual
Ikelite Digital Camera DS 50 User Manual