Grizzly Grinder H0589 User Manual

MODEL H0589

4" AIR DIE GRINDER

INSTRUCTION SHEET

⁄

EyE/EAR INJURy HAzARD!

Wear safety glasses and

hearing protection during

use of this tool!

INJURy HAzARD!

Always disconnect tool from

air to prevent unexpected

operation during service!

EXpLOSION HAzARD!

Never exceed 90 pSI! Always

use accessories with correct

speed rating.

Figure 1. Model H0589.

RESpIRATORy HAzARD!

Grinding produces fine

dust. Wear the appropriate

protection during use!

Die Grinder MUSt have 3-4 drops of oil directly

dropped into the air fitting before each use as

shown in Figure 2.

Introduction

No load speed is 20,000 RPM and collet size is

⁄

4". Requires maximum of 90 PSI with a minimum

of 4 CFM compressor capacity. Air inlet is ¹⁄4" and

air exhaust is in the rear. Weighs 1.2 lbs.

Inventory

A. Die Grinder................................................. 1

B. Wrenches ................................................... 2

Figure 2. Lubricating directly into air fitting.

If you need help with your new pneumatic tool,

call our Tech Support at: (570) 546-9663.

Operation

Insert your ¹⁄4" shank tool into the collet. Using the

two wrenches, secure tool by tightening the collet

nut against the spindle.

WARNING: NO pORTION OF THIS MANUAL MAy BE REpRODUCED IN ANy SHApE

OR FORM WITHOUT THE WRITTEN AppROvAL OF GRIzzLy INDUSTRIAL, INC.

#PC8027 PRINteD IN tAIWAN